Isotope-dilution ICP–MS for trace element determination and speciation: from a reference method to a routine method?

This critical review discusses the conditions under which inductively coupled plasma–isotope dilution mass spectrometry (ICP–IDMS) is suitable as a routine method for trace element and element-speciation analysis. It can, in general, be concluded that ICP–IDMS has high potential for routine analysis of trace elements if the accuracy of results is of predominant analytical importance. Hyphenated techniques with ICP–IDMS suffer both from lack of commercially available isotope-labeled spike compounds for species-specific isotope dilution and from the more complicated system set-up required for species-unspecific ICP–IDMS analysis. Coupling of gas or liquid chromatography with species-specific ICP–IDMS, however, enables validation of analytical methods involving species transformations which cannot easily be performed by other methods. The potential and limitations of ICP–IDMS are demonstrated by recently published results and by some unpublished investigations by our group. It has been shown that possible loss of silicon as volatile SiF₄ during decomposition of a sample by use of hydrofluoric acid has no effect on trace silicon determination if the isotope-dilution step occurs during digestion in a closed system. For powder samples, laser ablation ICP–IDMS can be applied with an accuracy comparable with that only available from matrix-matched standardization, whereas the accuracy of electrothermal vaporization ICP–IDMS was strongly dependent on the element determined. The significance of easy synthesis of isotope-labeled spike compounds for species-specific ICP–IDMS is demonstrated for monomethylmercury and Cr(VI). Isotope-exchange reactions between different element species can prevent the successful application of ICP–IDMS, as is shown for iodinated hydrocarbons. It is also shown for monomethylmercury that species transformations during sample-pretreatment steps can be followed by species-specific ICP–IDMS without loss of accuracy. A relatively simple and time-efficient procedure for determination of monomethylmercury in environmental and biological samples is discussed. The method, which entails a rapid microwave-assisted isotope dilution step and in-situ extraction of the derivatized species, has good potential for routine application in the future.     

微波消解ICP-MS法同时测定蔬菜中14种元素

研究了蔬菜中Ag、Al、As、Cd、Co、Cr、Cu、Mn、Ni、Pb、Sb、Se、Zn、Hg 14种元素同时准确测定的方法。用具孔电子控温加热板蒸干蔬菜样品,高压密闭微波化学工作站消解蔬菜干样,采用电感耦合等离子体质谱(ICP-MS)测定蔬菜中的14种元素。优化了微波消解条件和仪器测定条件。所有标准曲线的线性范围在0~200.0μg/L之间,回归方程的相关系数皆大于0.999,方法的检出限均小于0.22μg/L,加标回收率在81%~118%之间,精密度RSD小于4.44%;西红柿叶国家标准样品(GSBZ 51001-94)的验证分析,测定值均在保证值范围内。本方法具有快速、准确、可靠、灵敏度高及多元素同时分析等特点,可进行批量蔬菜样品测定,赋予"无公害蔬菜市场准入制度"的实施。     

Microchip Capillary Electrophoresis‐Electrochemistry with Rigid Graphite‐Epoxy Composite Detector

A new rigid graphite‐epoxy composite electrode for electrochemical detection in microchip electrophoresis is described. The end‐column wall‐jet detection design relying on tubular rigid composite working electrode shows favorably low noise level and high signal‐to‐noise ratio when compared to glassy carbon detector. The performance of rigid graphite‐epoxy composite detector was compared to glassy carbon detector using dopamine and catechol as model analytes. The various parameters of the microchip electrophoresis‐rigid graphite‐epoxy composite detector were optimized.     

刚性侧链型液晶高分子与含二维液晶基元的液晶高分子

提出了“刚性侧链型液晶高分子”与“含二维液晶基元的液晶高分子”两个新概念。     

矿物药中无机元素分布浅析

矿物药主要包括天然矿物,生物化石、加工品及纯粹化学制品学,主要成分均为无机化合物,依矿物中所含的主要或含量最多的元素和化合物分为九类,《矿物药与丹药》将矿药分为十种,根据矿物药中所含有效成分中可测元素分为十类。通过给矿物药分类,便于研究矿物药的理化性质,分析其有效成分或主要成分,探讨药理作用,明确主治范围,为寻求新药,开展新剂型创造条件。     

广州市夏、冬季室内外PM2.5中元素组分的特征与来源

通过采集广州市9个居民住宅室内、外的PM2.5样品,测定分析PM2.5中18个元素组分的质量浓度,分析讨论其污染、分布特征并解析其污染来源。经过比较得知,广州市PM2.5中元素污染较严重;不同类型住宅PM2.5中元素浓度存在空间分布特征;大部分元素浓度具有夏季比冬季低的变化特征;室内与室外元素浓度比值介于0.4974～2.0497之间;元素浓度的室内、室外相关拟合结果说明冬季室内空气受室外空气影响比夏季时情况更明显;基于富集因子分析,Se、As、S、Pb、Br、Zn和Cl元素高度富集;Ni、V、Cu元素中等富集,主要来自人为源,而Cr、Sr、K、Mn、Ca和Ti元素不富集,主要来自自然源。     

Effect of matrix chain length on the electrophoretic mobility of large linear and branched DNA in polymer solutions

We study the effect of matrix chain molecular weight Mw and concentration c on the electrophoretic mobility micro of large linear and star-like, branched DNA in polymer solutions. Polyethylene oxide (PEO) with narrow molecular weight distributions form the main focus of this study. For PEO concentrations ranging from one half the overlap concentration, c*, to 3c*, the effective drag coefficient, zeta is identical with (mu0/mu) - 1, satisfies the following approximate scaling relationship, zeta approximately cMw(0.7). Here, mu0 is the electrophoretic mobility in free solution. While the concentration dependence is consistent with predictions from the transient entanglement coupling (TEC) model, the molecular weight dependence is significantly weaker. Although a similar dependence of mobility on Mw can be predicted when nonentangling collisions are the dominant source of drag, a model based on these collisions alone cannot reproduce the experimental observations. We also find that the architecture of large DNA does not affect either the concentration dependence or molecular weight dependence of the electrophoretic mobility.     

高氟、全氟有机化合物中碳氢氮的微量分析

应用Vario EL Ⅲ型元素分析仪研究了高氟和全氟有机化合物中碳、氢、氮的测定方法.为克服氟对碳、氮测定的干扰,在燃烧管的高温区填加固体MgO及Ag2WO4混合物作为催化氧化剂.这一措施还可同时消除卤素及硫的干扰.在分析全氟有机化合物时,则将WO3及V2O5作为催化氧化剂直接加入于试样中并包裹于"锡舟"中进行燃烧和碳、氢、氮的测定.     

Stereoselective synthesis of an ansa-zirconocene in a spirane scaffold

Methodology is described for the preparation of a rigid C₂-bridged zirconocene catalyst system where the C₂-bridge is embedded in a spirane scaffold. The ligand was prepared from 3,4-dihydro-2H-fluoren-1(9H)-one. Initially, the oxo group was converted into a spirocyclobutanone function. Further conversion to a fulvene was followed by regio- and stereoselective saturation to provide the ligand cis-2-(cyclopentadienyl)-1′,2′,3′,4′-tetrahydro-9H-spiro[cyclobutane-1,1′-fluorene]. The ligand was dilithiated and reacted with zirconium tetrachloride to provide the corresponding (η⁵-cyclopentadienyl)-spiro[cyclobutane-1,1′-(η⁵-fluorenyl)]zirconium dichloride complex. The structure of the zirconocene dichloride has been established by crystal X-ray analysis.     

The amount of immobilized polymer in PMMA SiO2 nanocomposites determined from calorimetric data

For semicrystalline polymers there is an ongoing debate at what temperature the immobilized or rigid amorphous fraction (RAF) devitrifies (relaxes). The question if the polymer crystals are melting first and simultaneously the RAF devitrifies or the RAF devitrifies first and later on the crystals melt cannot be answered easily on the example of semicrystalline polymers. This is because the crystals, which are the reason for the immobilization of the polymer, often disappear (melt) in the same temperature range as the RAF. For polymer nanocomposites the situation is simpler. Silica nanoparticles do not melt or undergo other phase transitions altering the polymer-nanoparticle interaction in the temperature range where the polymer is thermally stable (does not degrade). The existence of an immobilized fraction in PMMA SiO₂ nanocomposites was shown on the basis of heat capacity measurements at the glass transition of the polymer. The results were verified by enthalpy relaxation experiments below the glass transition. The immobilized layer is about 2 nm thick at low filler content if agglomeration is not dominant. The thickness of the layer is similar to that found in semicrystalline polymers and independent from the shape of the nanoparticles. Nanocomposites therefore offer a unique opportunity to study the devitrification of the immobilized fraction (RAF) without interference of melting of crystals as in semicrystalline polymers. It was found that the interaction between the SiO₂ nanoparticles and the PMMA is so strong that no devitrification occurs before degradation of the polymer. No gradual increase of heat capacity or a broadening of the glass transition was found. The cooperatively rearranging regions (CRR) are either immobilized or mobile. No intermediate states are found. The results obtained for the polymer nanocomposites support the view that the reason for the restricted mobility must disappear before the RAF can devitrify. For semicrystalline polymers this means that rigid crystals must melt before the RAF can relax.